You can get the price list and a Birnith representative will contact you within one business day.

  • Calculate 2" Minus Road base (RCA) | cubic yards / Tons

    Type in inches and feet of your project and calculate the estimated amount of Recycled Materials in cubic yards, cubic feet and Tons, that your need for your project. The Density of 2" Minus Road base (RCA): 2,410 lb/yd³ or 1.21 t/yd³ or 0.8 yd³/t

    Get Price
  • DETERMINING UNIT MASS (WEIGHT) OF AGGREGATES

    4.1 Determining Unit Mass (Weight)—Loose Method: 4.1.1 Coarse Aggregate: 4.1.1.1 Place the sample on a smooth, flat surface and mix thoroughly. 4.1.1.2 Place the 0.01 m3 (0.5 ft.3) measure on a level surface near the sample. 4.1.1.3 Take a medium scoop of the aggregate from the thoroughly mixed sample pile.

    Get Price
  • Standard Test Method for Bulk Density ("Unit Weight") and ...

    1.1 This test method covers the determination of bulk density ("unit weight") of aggregate in a compacted or loose condition, and calculated voids between particles in fine, coarse, or mixed aggregates based on the same determination. This test method is applicable to aggregates not exceeding 125 mm [5 in.] in nominal maximum size.

    Get Price
  • Voids, settlement and weight of crushed stone,

    the weight of a unit of solid stone is useful in determining the. weight of a unit of volume of broken stone. The percentage of voids may be determined in either of two. ways: (1) by pouring in water; and (2) by computation from the. specific gravity and the weight of a volume of broken stone.

    Get Price
  • unit weight of crushed aggregate

    unit weight of crushed aggregate Determination of Unit Weights of Aggregates in the mix into which the aggregate is placed rather than on the unit price of the aggregate itself, That being the case, if it becomes necessary to con­ dense the information that has been placed in Table IV, it is probable tho.t unit weights representing sizes 36, 47, 610 and 10 would be the most...

    Get Price
  • September 1, 2003 CONCRETE MANUAL 5-694.300 MIX .

    The absorbed water of an aggregate is the water contained within the pores of the aggregate and is held within the particles by capillary force. The ab sorption factor is expressed as a decimal and is the ratio of the mass (weight) of water for saturation of the aggregate to the oven-dry mass (weight) of the aggregate.

    Get Price
  • Specifications For CRUSHED AGGREGATE BASE COARSE #2 .

    Crushed aggregate base coarse (Compaction Gravel) shall be purchased per standard ton with a standard ton to weight 2,000 pounds for the purpose of this contract. Material shall be .

    Get Price
  • **********************************************************

    AGGREGATE BASE COURSES 08/17 PART 1 GENERAL 1.1 UNIT PRICES 1.1.1 Measurement 1.1.1.1 Area 1.1.1.2 Volume 1.1.1.3 Weight 1.1.2 Payment 1.1.2.1 Base Course Material 1.1.2.2 Stabilization 1.1.3 Waybills and Delivery Tickets 1.2 REFERENCES 1.3 DEFINITIONS 1.3.1 Aggregate Base Course 1.3.2 Graded-Crushed Aggregate Base Course

    Get Price
  • 3 Aggregate Properties

    Density is the weight per unit of volume of a substance. Specific gravity is the ratio of the density of the substance to the density of water. 3-3 The following chart illustrates these relationships for some common ... Crushed aggregate have irregular, angular particles that tend to interlock when

    Get Price
  • Iowa oversize permits - regulations and information

    An amber revolving light at least 7″ high and 7″ in diameter is required on the towing unit whenever length exceeds 85′, front overhang exceeds 25′ or rear overhang exceeds 10′ (light should be on the load in the rear) or weight exceeds 80,000 lbs. An escort can be used in lieu of amber light.

    Get Price
  • Designation: D4718 – 87 (Reapproved 2007)

    Designation: D4718 – 87 (Reapproved 2007) Standard Practice for Correction of Unit Weight and Water Content for Soils Containing Oversize Particles1 This standard is issued under the fixed designation D4718; the number immediately following the designation indicates the year of

    Get Price
  • Crushed Aggregate Base Course Materials Unit Weight

    unit weight of crushed aggregate. the crushed aggregate base material shall be placed on the moistened astm c 29 unit weight of aggregate astm c 88 soundness of aggregates by ... course aggregate, ...

    Get Price
  • Aggregate | Quality Construction Materials | Pennsy Supply

    AASHTO #57. This material has a 1-1/2 inch top size and is a clean material. Often used for backfill for retaining walls, used for subase for sheds, also sometimes used as driveway stone. Also used as the primary raw aggregate in Ready Mixed Concrete and some Hot-Mixed Asphalt mixes. Will not compact.

    Get Price
  • crushed stone base unit weight

    Standard Weights for Crushed Rock Per Meter | Hunker. The weight of crushed rock will vary greatly depending on the type of the stone and the size and uniformity of the crush. The smaller the crush size, the heavier the load.Solid rock is estimated at 2.5 to 3tons per cubic meter. Get Price

    Get Price
  • IDOT- CA 6

    Unit Weights (AASHTO T 19) Rodded Unit Weights lbs/ft3 106 N/A lbs/yd3 2,862 ton/yd3 1.431 Standard Proctor (AASHTO T 99) Optimum Moisture 9.8% N/A Max. Dry Density 113.3 lbs/ft³ N/A Max. Wet Density 124.9 lbs/ft³ N/A All data is based on material averages and are in compliance with IDOT Standards. Actual production a runs may vary.

    Get Price
  • Aggregate - AfriSam

    • Speciality aggregate include railway ballast, gabion and other larger sized crushed stone used in erosion protection, architectural and landscaping. Aggregate AfriSam Aggregate products are available in Gauteng, Mpumalanga, KwaZulu-Natal and the Western Cape, allowing builders, developers, architects and engineers access to AfriSam expertise,

    Concrete Mix Design: Understanding Aggregate - NPCA

    Mar 02, 2018· The weight of the aggregate is measured and divided by the volume of the measure used to yield the DRUW. Results are expressed as mass per volume. For example, a given crushed limestone could weigh 93 lbs./ft.3. By knowing the DRUW of a coarse aggregate, the maximum nominal aggregate size and the fineness modulus of the fine aggregate, the weight of the coarse aggregate needed per .

    Get Price
  • unit weight of crushed surfacing top course

    Jul 1, 2013 ... Unit Dry Weight ... Direct attention to the inclusion of crushed surfacing top course .... S1 = Top Shoulder Slope (Varies –0.02 ft/ft or –0.05 ft/ft). More details » Get Price

    Get Price
  • unit weight of crushed surfacing top course

    Chapter 620 - Washington State Department of Transportation. Jul 1, 2013 ... Unit Dry Weight ... Direct attention to the inclusion of crushed surfacing top course .... S1 = .

    Get Price
  • SECTION 2 BACKFILL - Alberta

    Non Granular Material (Soil) ASTM D689 One test for each significant soil type Density of Materials (In-place) 1. Crushed Aggregate (Des 2 Class 25) ASTM D2922 ATT 8 or 9 Three tests on Culvert Bedding taken at invert level Three tests for every four lifts of backfill 2.

    Get Price
  • OVERSIZE LOAD - NCDOT

    the NCDOT Oversize/Overweight Permit Unit. Expiration and Renewal Certificates will be valid for four years from the date of issue. At least two months before expiration date, contact the NCDOT Oversize/Overweight Permit Unit (see Appendix B) to obtain procedure for renewal. Page 1 -3

    Unit Weight Of Crushed Aggregate | Blog Dandk

    Mar 02, 2018· Unit Weight Of Crushed Aggregate. Vernia Verbasco March 2, 2018. I hope this will help you cast stone physical properites comparison chart aggregate classification specific gravityaggregate weight. What Is The Unit Weight Of Brick Cement Concrete Aggregate Quora -> Source

    Get Price
  • Standard Test Methods for Laboratory Compaction ...

    appropriate field in-place unit weight (or density) test specimen using Practice D4718. 1.5 This test method will generally produce a well-defined maximum dry unit weight for non-free draining soils. If this test method is used for free-draining soils the maximum unit weight may not be well defined, and can be less than obtained

    Get Price
  • CONCRETE MIX DESIGN USING CRUSHED SAND

    concrete mix design using crushed sand Home / Concrete Technology / CONCRETE MIX DESIGN USING CRUSHED SAND The process of selecting suitable ingredients of concrete and determining their relative amounts with the objective of producing a concrete of the required, strength, durability, and workability as economically as possible, is termed the ...

    Get Price
  • Application for Permission to Move an Oversize/Weight Load

    Application for Permission to Move an Oversize/Weight Load This is only an application for PERMISSION to move a vehicle to a port of entry to obtain an oversize and or overweight permit. Vehicles that proceed beyond the selected location without a permit are in violation.

    Section 306 AGGREGATE SURFACE COURSE

    aggregate surface course applications, compact each layer of aggregate to at least 95 percent of the maximum unit weight, at a moisture content no greater than optimum. Shape the finished surface and layers to within ±½ inch of the crown and grade shown on the plans. If placing aggregate base in a layer no greater than 3 inches, compact

    Get Price
  • A new procedure for determining dry density of mixed soil ...

    A new procedure for determining dry density of mixed soil containing oversize gravel. ... and gravel content on the maximum dry unit weight and optimum water content. Current methods for ...

    Crushed Stone: Determing Yards Per Ton

    Crushed stone is quoted at a weight of 2700 pounds per cubic yard. Your stone dealer tells you he has a truck that can deliver 20 tons of stone per load. You need to .

    Get Price
  • Gravel Calculator - how much gravel you need in tons ...

    Free gravel calculator online: estimate how much gravel you need for your construction or gardening / landscaping project. Calculates gravel required in volume: cubic feet, cubic yards, cubic meters, or weight: pounds, tons, kilograms, tonnes... Information about gravel density, common gravel sizes, how much a cubic yard of gravel weighs, how much a cubic meter of gravel weighs, and more.

    Get Price
  • Aggregate | Quality Construction Materials | Pennsy Supply

    Pennsy Supply is the largest producer of aggregate in central Pennsylvania, producing more than nine million tons every year consisting of primarily crushed stone, sand and gravel. Quality construction materials are at the core of Pennsy Supply!

    Get Price
  • 32 11 23 - AGGREGATE BASE COURSE

    C. Unit Price: 1. If the Bid Schedule indicates a unit price for aggregate base course, the unit price method of measurement and payment will be as follows: a. Measurement: Aggregate base course will be measured for payment by the cubic yard of each class of aggregate placed in the Work.

    Get Price
  • Fulfillment fees for Multi-Channel Fulfillment orders ...

    1 The unit weight is the weight of an individual unit.. 2 The packaging weight is the weight of the box and packing materials. Amazon uses these standardized weights for calculating shipping weight. 3 For large standard-size units weighing more than 1 lb and all small oversize, medium oversize, and large oversize units, Amazon uses dimensional weight when it is greater than the unit weight.

    Get Price
  • Crushed Stone: Determing Yards Per Ton

    Tons are a weight measure. To make matters even more confusing is the fact that determining yards per ton is anything but an exact science. The weight of crushed stone in pounds per cubic yards and tons per cubic yards are approximate measures that assume all of the same material weighs the same.

    Get Price
  • Crushed stone - Wikipedia

    Crushed stone has one of the lowest average by weight values of all mineral commodities. The average unit price increased from US$1.58 per metric ton, f.o.b. plant, in 1970 to US$4.39 in 1990. However, the unit price in constant 1982 dollars fluctuated between .

    Get Price